SimpLinx Support

Sendgrid Setup for Email Sending:

Select “Settings” category from menu.
Select “Email Connector” to set your Sendgrid account for sending mails.

Choose “Type” for SENDGRID.
Write your username which is default to “apikey” when you create key. If your username is not “apikey”, write your username.
Write your password.

To use “Sendgrid” for sending emails follow these steps:
Go to sendgrid page, If you have already an account please log in, otherwise create new account for sendgrid.

After filling in the required fields, click “Create Account” button.
New screen will pop up and fill required fields again and then click “Get Started”.

After creating or loging your account, on the opened page there will be button called “Create a Single Sender”, click it.

After clicking it, new screen will pop up.
Please fill in the required fields and click “Create” button.

To verify sender identity, check your inbox.

After verify your sender identiy, you will see green thick under the “Verified” section.
Now on the left side of the screen, there is section called “EMAIL API“. Click it then select “Integration Guide”.

In this page, there will be two sections, please choose “SMTP Relay” option.

In this page, you can create new an API key.
Choose any name for your API key name.
Then select “Create Key” button.

After clicking Create Key button your new password will be generated, you can use this password in email connector page for “SENDGRID” option.