How to Read Data from Beijer Modules

remote-io-beijer-6.jpg


As shown above, it is possible to directly read input values that support Modbus TCP communication without the aid of a PLC or similar device.

After the data is read, it can be recorded, analyzed and sent to the cloud.

Required Hardware List

  • SMX-RNS02
  • Beijer FnIO-S : Modbus TCP Remote IO Module
  • Beijer ST-1214 : Digital IO Module
  • Beijer ST-2324 : Digital IO Module
  • 24V Power Supply
  • Ethernet Cable (1m)

Installing the Hardware

  • Arrange the power supply, SMX-RNS02 and Beijer modules on the rail as shown in the photo
  • Connect SMX-RNS02 (LAN1) and Beijer communication module with Ethernet cable
  • It is assumed that the Beijer modules are pre-installed (IP assignment etc …). If pre-installation is not done, please follow the relevant documents.
  • Make power connections of SMX-RNS02 and Beijer communication module (24V)
  • Energize the power supply

Read Data

  • Open the Remote-IO application running on SMX-RNS02
    • You can reach the web interface from the service port via cable, wireless accessory or over remote connection.
    • Type http://192.168.169.254:8080 in your browser and press Enter
    • Enter your username and password on the login page
  • You can refer to the related user documentation for the Remote IO
  • You can follow the steps shown in the photos below in order.


Add a new Driver

Create your tags

Check Driver & Tag statuses from Status Pages

References